Once installed you will need to begin configuration your WinALDL program to start logging that data. After installing, run the WINALDL Software and click the configuration button and choose the ECM type and choose METRIC. Also, set the com port that your ALDL cable is plugged into and if your using a USB cable set the baud rate to 4800. USB to ALDL Cable comes with 3' USB extension cable, and Driver/Software CD. Switchable 10K ohm A-B resistor is built in and can also be turned off.

About WinALDL is software to datalog on GM vehicles that use the old 160 baud rate. This includes but is not limited to vehicles using a 1227747 and 1227165 ECM.

So, as an instance, you may print from a far-flung word processor to a neighborhood printer. This is a mature era, strong and punctiliously concept out. Winxp sp3 activation crack. This is not merely filed access–this generation lets you run packages remotely as in case you have been sitting at your table at paintings. A version on the subject is Remote Assistance, in which the person can permit a far-flung helper to view their computer, or optionally benefit manage of the keyboard and mouse so that you can troubleshoot a hassle. A general XP function, this uses era from Microsoft Terminal Server to allow users to get right of entry to their computer over any connection; as an instance, by way of dialing into the office from home.

Most older TBI GM computers will speak this protocol. WinALDL does NOT speak to newer GM OBD1 vehicles that use 8192 baud communication.

WinALDL is available from WinALDL was written several years ago. It will work best on Windows XP or older operating systems, if available.

You may need to use a VM or Windows XP compatibility mode on newer Windows7 systems in order for it to run 100% properly. WinALDL will work with both our ALDU1 and AutoProm. Skanvord teschin yazik raspechatatj pdf. Setup There are a few setup tasks that need to be performed. • Ensure that your ALDU1 or AutoProm is assigned a COM port between 1 and 4. Make sure you choose a port that does not conflict with system resources.

(see ) • If you are using the AutoProm, ensure that it is set to pass-through *NOT* AutoProm mode. (see ) • On most 160 baud applications, you will need to set the switch to 10k mode on your AutoProm or ALDU1 • Set the COM port selection in WinALDL to match what it set up to on the USB driver under the control panel. • Set the baud rate to 4800 within the WinALDL program.

• Select the ECM type in WinALDL which matches your ECM. • Make sure the ALDU1 is connected to the laptop prior to starting the software.

• Turn your key off, connect the ALDU1 to the car, and start the software. • Turn the car on, it should connect.

Get connected and start scanning! The interface cable works on all General Motors OBDI/ALDL cars and trucks that use either a 160 or 8192 baudrate datastream ( approx.

1982-1995 model years). There is no need for any external COM port adaptors. The interface goes straight from ALDL to USB. Just plug the cable into your computer's USB-port and you are ready to go! The USB-to-ALDL Interface Cable is not limited to use with just our GMTDScan software.

It works with all available OBDI/ALDL scanning and tuning software on the market today, e.g. TunerPro, DataMaster and WinALDL. Does not work with DOS-based applications like Craig Moates ECM852 or similar software. USB-to-ALDL Interface Cable features.